Chelsio Communications Chelsio T5 Guía de usuario descargar pdf (Pagina 181)

100

101

Chapter XI. FCoE Full Offload Initiator

Chelsio T5/T4 Unified Wire For Linux Page 181

4. Software/Driver Configuration and Fine-tuning

4.1. Configuring Cisco Nexus 5010 and Brocade switch

To configure various Cisco and Brocade switch settings, please refer Software/Driver

Configuration and Fine-tuning section of Data Center Bridging (DCB) chapter.

4.2. FCoE fabric discovery verification

4.2.1. Verifying Local Ports

Once connected to the switch, use the following command to see if the FIP has gone through

and a VN_Port MAC address has been assigned.

Verify if all the FCoE ports are online/ready and a successful FIP has taken place using the

following command. The wwpn and state of the initiator local port can be found under sysfs.

[root@host]# cat /sys/class/fc_host/hostX/port_name

Alternatively, the local port information can also be found using:

[root@host]# cxgbtool stor –a <adapter_no> --show-lnode

 The hosts under fc_host depends on the number of ports on the adapter

used.

 Inorder to identify chelsio fc_host from other vendor fc_host, the WWPN

always begins with 0x5000743

Note

1 2 ... 176 177 178 179 180 181 182 183 184 185 186 ... 459 460

Comentarios a estos manuales

Sin comentarios

Chelsio Communications Chelsio T5 Guía de usuario Pagina 181

Comentarios a estos manuales

Relacionado con productos y manuales para Software Chelsio Communications Chelsio T5