Chelsio Communications Chelsio T5 Guía de usuario Pagina 155

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 452
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 154
Chapter IX. FCoE Full Offload Initiator
Chelsio T5/T4 Unified Wire For Linux Page 155
ii. Create a CEE Map to carry LAN and SAN traffic if it does not exist. Example of creating a
CEE map.
switch(config)# cee-map default
switch(conf-cee-map)#priority-group-table 1 weight 40 pfc
switch(conf-cee-map)#priority-group-table 2 weight 60
switch(conf-cee-map)#priority-table 2 2 2 1 2 2 2 2
iii. Configure the CEE interface as a Layer 2 switch port. Example of configuring the switch port
as a 10-Gigabit Ethernet interface.
switch(config)#interface tengigabitethernet 0/16
switch(config-if-te-0/16)#switchport
switch(config-if-te-0/16)#no shutdown
switch(config-if)#exit
iv. Create an FCoE VLAN and add an interface to it. Example of creating a FCoE VLAN and
adding a single interface.
switch(config)#vlan classifier rule 1 proto fcoe encap ethv2
switch(config)#vlan classifier rule 2 proto fip encap ethv2
switch(config)#vlan classifier group 1 add rule 1
switch(config)#vlan classifier group 1 add rule 2
switch(config)#interface vlan 1002
switch(conf-if-vl-1002 )#fcf forward
switch(conf-if-vl-1002 )#interface tengigabitethernet 0/16
switch(config-if-te-0/16)#switchport
switch(config-if-te-0/16)#switchport mode converged
switch(config-if-te-0/16)#switchport converged allowed vlan add 1002
switch(config-if-te-0/16)#vlan classifier activate group 1 vlan 1002
switch(config-if-te-0/16)#cee default
switch(config-if-te-0/16)#no shutdown
switch(config-if-te-0/16)#exit
Unlike cisco, only one VLAN ID can carry FCoE traffic for now on Brocade 8000.
It is their limitation.
Note
Vista de pagina 154
1 2 ... 150 151 152 153 154 155 156 157 158 159 160 ... 451 452

Comentarios a estos manuales

Sin comentarios