Chelsio Communications Chelsio T5 Guía de usuario descargar pdf (Pagina 154)

100

101

Chapter IX. FCoE Full Offload Initiator

Chelsio T5/T4 Unified Wire For Linux Page 154

iv. Enabling DCBX:

switch(config)# interface ethernet 1/13

switch(config-if)# priority-flow-control mode auto

switch(config-if)# flowcontrol send off

switch(config-if)# flowcontrol receive off

switch(config-if)# lldp transmit

switch(config-if)# lldp receive

switch(config-if)# no shutdown

v. On the FC Ports, if a FC target is connected then perform the following steps -

switch(config)#vsan database

switch(config-vsan-db)#vsan 2

switch(config-vsan-db)# vsan 2 interface fc 2/2

switch(config-vsan-db)#exit

switch(config)interface fc 2/2

switch(config-if)# switchport mode auto

switch(config-if)# switchport speed auto

switch(config-if)# no shutdown.

vi. If you have not created a zone then make sure the default-zone permits the VSAN created,

otherwise the initiator and the target on that particular VSAN although FLOGI’d into the

switch will not talk to each other. To enable it, execute the below command.

switch(config)# zone default-zone permit vsan 2

4.1.3. Configuring the Brocade 8000 switch

i. Configure LLDP for FCoE.Example of configuring LLDP for 10-Gigabit Ethernet interface.

switch(config)#protocol lldp

switch(conf-lldp)#advertise dcbx-fcoe-app-tlv

switch(conf-lldp)#advertise dcbx-fcoe-logical-link-tlv

1 2 ... 149 150 151 152 153 154 155 156 157 158 159 ... 451 452

Comentarios a estos manuales

Sin comentarios

Chelsio Communications Chelsio T5 Guía de usuario Pagina 154

Comentarios a estos manuales

Relacionado con productos y manuales para Software Chelsio Communications Chelsio T5