Chelsio Communications Chelsio T4 Guía de usuario descargar pdf (Pagina 146)

100

101

Chapter IX. FCoE Full Offload Initiator

i. Following steps will enable FCoE services on a particular VLAN and does a VSAN-VLAN

mapping. Need not do these steps every time, unless a new mapping has to be created.

switch(config)# vlan 2

switch(config-vlan)# fcoe vsan 2

switch(config-vlan)#exit

ii. Following steps help in creating a virtual fibre channel (VFC) and binds that VFC to a

Ethernet interface so that the Ethernet port begins functioning as a FCoE port.

switch(config)# interface vfc 13

switch(config-if)#bind interface ethernet 1/13

switch(config-if)# no shutdown

switch(config-if)#exit

switch(config)#vsan database

switch(config-vsan-db)# vsan 2

switch(config-vsan-db)#vsan 2 interface vfc 13

switch(config-vsan-db)#exit

iii. Assign VLAN ID to the Ethernet port on which FCoE service was enabled in step1.

switch(config)# interface ethernet 1/13

switch(config-if)#switchport mode trunk

switch(config-if)#switchport trunk allowed vlan 2

switch(config-if)#no shutdown

switch(config)#exit

If you are binding the VFC to a MAC address instead of an ethernet port then

make sure the ethernet port is part of both default VLAN and FCoE VLAN.

Note

1 2 ... 141 142 143 144 145 146 147 148 149 150 151 ... 373 374

Comentarios a estos manuales

Sin comentarios

Chelsio Communications Chelsio T4 Guía de usuario Pagina 146

Comentarios a estos manuales